[c-nsp] 6500/7600 "reserved" power for secondary sups

Richard A Steenbergen ras at e-gerbil.net
Fri Mar 3 15:28:59 EST 2006


Hello,

Is there a way to disable the automatically reserved power for a secondary 
supervisor on the 6500/7600s? For example:

system power redundancy mode = redundant
system power total =     2331.00 Watts (55.50 Amps @ 42V)
system power used =      1280.53 Watts (30.49 Amps @ 42V)
system power available = 1050.47 Watts (25.01 Amps @ 42V)
                        Power-Capacity PS-Fan Output Oper
PS   Type               Watts   A @42V Status Status State
---- ------------------ ------- ------ ------ ------ -----
1    WS-CAC-2500W       2331.00 55.50  OK     OK     on 
2    WS-CAC-2500W       2331.00 55.50  OK     OK     on 
                        Pwr-Requested  Pwr-Allocated  Admin Oper
Slot Card-Type          Watts   A @42V Watts   A @42V State State
---- ------------------ ------- ------ ------- ------ ----- -----
1    WS-X6704-10GE       295.26  7.03   295.26  7.03  on    on
3    WS-X6748-SFP        328.44  7.82   328.44  7.82  on    on
5    WS-SUP720-3BXL      328.44  7.82   328.44  7.82  on    on
6    (Redundant Sup)       -     -      328.44  7.82  -     -

Under slot 6, the system is reserving power for 328.44 watts (the same as 
the primary sup720-3bxl), but there is no card in slot 6, nor has there 
ever been.

-- 
Richard A Steenbergen <ras at e-gerbil.net>       http://www.e-gerbil.net/ras
GPG Key ID: 0xF8B12CBC (7535 7F59 8204 ED1F CC1C 53AF 4C41 5ECA F8B1 2CBC)


More information about the cisco-nsp mailing list