[c-nsp] EtherChannel 6500 Question

Paul Stewart pstewart at nexicomgroup.net
Fri Mar 10 08:21:54 EST 2006


Hi Rubens...

Thanks for the reply... That's pretty well what I'm going to end up
doing on L2.... :)

Paul
 

-----Original Message-----
From: Rubens Kuhl Jr. [mailto:rubensk at gmail.com] 
Sent: Thursday, March 09, 2006 10:39 PM
To: Paul Stewart
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] EtherChannel 6500 Question

I don't think there is one. You should use either L2 or L3
load-balancing to achieve this. L2 way is setting
per-vlan-spanning-tree, and making one path active and the other backup
for half of the vlans, and the other way around for the others.
L3 way is CEF loadsharing, 2 routes for each destination.


Rubens


On 3/10/06, Paul Stewart <pstewart at nexicomgroup.net> wrote:
> Does anyone know of a way to do an Etherchannel setup using more than 
> one switch at each end?
>
> I have an application where I want to take a 2950 on one side using 4 
> FE's and use etherchannel to carry that traffic to two separate 6509's

> using 2 FE's on each with Etherchannel?
>
> Thanks,
>
> Paul Stewart
> IP Routing/Switching
> Nexicom Inc.
> http://www.nexicom.net/
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>



More information about the cisco-nsp mailing list