[c-nsp] ACL on cisco2948 not work

[Erdem Sener]

Hi,

 for 2948G-L3, I remember something like 'ACL card' for full ACL
support. There's a great chance I might be mistaken, though..

Erdem

On 5/19/06, Suchy Daniel <ds at nix.cz> wrote:
> Hi Joe,
> if you're talking about Catalyst 2948G-L3 - there is "small" limitation
> in ACL support - ACLs are supported only on gigabit interfaces, not on
> 10/100 (it's also noted in documentation).
>
> Dan
>
> Joe Shen wrote:
> > Hi,
> >
> >
> > I'm trying to set up ACL on Cisco2948. The acl is to
> > be applied on an access interface.
> >
> > But, after I set up ACL and applied to the access port
> > it seems no packet is filtered out although it should.
> >
> >
> > why?
> >
> > joe
> >
> >
> >
> >
> >
> >
> > ___________________________________________________________
> > Mp3疯狂搜-新歌热歌高速下
> > http://music.yahoo.com.cn/?source=mail_mailbox_footer
> > _______________________________________________
> > cisco-nsp mailing list  cisco-nsp at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-nsp
> > archive at http://puck.nether.net/pipermail/cisco-nsp/
>
>
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
>
>


-- 
Erdem
"http://tr1.monstersgame.net/?ac=vid&vid=20030512"