[c-nsp] PDSN implementation

[Collins, Richard (SNL US)]

This is what we have used.  A colleague ran some basic test with Radius
but without all the attributes you need to really run CDMA (that was my
understanding).

-Rich
------------------------------------------------------------------------
-----------------
pdsn#sh hardware 
Cisco IOS Software, 7200 Software (C7200-C6IS-M), Version 12.3(11)YF4,
RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Wed 31-Aug-05 21:58 by evmiller

ROM: System Bootstrap, Version 12.3(4r)T3, RELEASE SOFTWARE (fc1)
BOOTLDR: 7200 Software (C7200-KBOOT-M), Version 12.3(9), RELEASE
SOFTWARE (fc2)

pdsn uptime is 12 weeks, 4 days, 6 hours, 45 minutes
System returned to ROM by power-on
System image file is "disk2:/c7200-c6is-mz.123-11.YF4.bin"

Cisco 7206VXR (NPE-G1) processor (revision B) with 983040K/65536K bytes
of memory.
Processor board ID 34778679
SB-1 CPU at 700MHz, Implementation 1025, Rev 0.2, 512KB L2 Cache
6 slot VXR midplane, Version 2.11

Last reset from power-on

PCI bus mb1 (Slots 1, 3 and 5) has a capacity of 600 bandwidth points.
Current configuration on bus mb1 has a total of 0 bandwidth points. This
configuration is within the PCI bus capacity and is supported. 
          
PCI bus mb2 (Slots 2, 4 and 6) has a capacity of 600 bandwidth points.
Current configuration on bus mb2 has a total of 0 bandwidth points. This
configuration is within the PCI bus capacity and is supported. 

Please refer to the following document "Cisco 7200 Series Port Adaptor
Hardware Configuration Guidelines" on CCO <www.cisco.com>, for c7200
bandwidth points oversubscription/usage guidelines.


3 Gigabit Ethernet interfaces
509K bytes of NVRAM.

125440K bytes of ATA PCMCIA card at slot 2 (Sector size 512 bytes).
16384K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2102

pdsn# 


------------------------------

Message: 6
Date: Thu, 02 Nov 2006 22:29:37 +0300
From: Rivo Tahina RAZAFINDRATSIFA <r.tahina at wanadoo.mg>
Subject: [c-nsp] PDSN implementation
To: cisco-nsp at puck.nether.net
Message-ID: <5.1.0.14.0.20061102222718.0133d240 at pop.wanadoo.mg>
Content-Type: text/plain; charset="us-ascii"; format=flowed

Hi all,

I would to know if someone has any idea about using a 7200 box as a CDMA

PDSN, what about hardware config and which IOS to use?

Kind regards.