[c-nsp] Subinterfaces on a 6500 Native?

[Church, Chuck]

Don't subints on a 6500 require a Sup720 or an OSM?  I seem to remember
something like that... 


Chuck Church
Network Engineer
CCIE #8776, MCNE, MCSE
Multimax, Inc.
Enterprise Network Engineering
Home Office - 864-335-9473 
Cell - 864-266-3978
cchurch at multimax.com

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Deepak Jain
Sent: Tuesday, October 03, 2006 3:47 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] Subinterfaces on a 6500 Native?


What is the minimum software rev for a 6500/7600 running IOS Native to 
support (dot) or Subinterfaces for L3 VLAN encapsulation?

6500(config)#int g2/12
6500(config-if)#int g2/12.200
                             ^
% Invalid input detected at '^' marker.

6500(config)#encap ?
% Unrecognized command

The software rev is:

Cisco Internetwork Operating System Software
IOS (tm) c6sup2_rp Software (c6sup2_rp-PSV-M), Version 12.1(22)E6, 
RELEASE SOFTWARE (fc1) which I was pretty supported it unless I am 
missing something obvious.

interface GigabitEthernet2/12
  ip address 192.168.0.1 255.255.255.252
  shutdown
!

Thanks in advance,

Deepak
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/