[c-nsp] egress replication capability on CFCs?

[christian.macnevin at uk.bnpparibas.com]

Right, now I remember, it was the lookups alone, not the actual 
replication.

Our recommendation from your learned selves so far has been to stick away 
from egress replication in
financial networks until it's a bit more mature, and hard code the devices 
to ingress.

How strong is egress replication looking these days? I imagine many of the 
service provider psychos
with their MVPNs might be running it? :P






Internet
tstevens at cisco.com

09/10/2006 18:45

To
Christian MACNEVIN, cisco-nsp
cc

Subject
Re: [c-nsp] egress replication capability on CFCs?






Christian,

Strictly speaking, no, egress replication does NOT require DFC, it 
only requires a switch fabric & egress capable replication engines on 
the linecards (such as those on 67xx cards).

The auto-detection is based only on card type, not whether there is a 
DFC present. It could be argued either way which is the better mode 
for CFC equipped cards, ingress or egress.

With CFC, egress replication still gives you decreased fabric 
bandwidth consumption and distributed replication - but, at the same 
time, it could increase your system bus utilization, especially in a 
VLAN/SVI or distributed etherchannel environment, because you may do 
multiple lookups for the "same" OIF, one for each egress card with 
that OIF (eg, SVI 100 on cards 1 2 & 3 would each submit a lookup for 
the replicated copy to the PFC over the bus in egress mode; vs 
ingress mode where only one copy would be looked up at the PFC).

In the end, though, at realistic packet sizes & data rates, this is 
probably not a major consideration, but you should probably consider 
monitoring bus, fabric, and fwding engine utilization to make sure 
you're not on the hairy edge.

Thanks,
Tim

At 04:51 PM 10/9/2006 +0100, christian.macnevin at uk.bnpparibas.com 
commented:
>Hi,
>
>I was under the impression that egress multicast replication required an
>onboard DFC on a 67XX card, yet
>I've got a box fully populated with 6748-SFP cards here telling me it's
>current mode of replication is Egress.
>
>Doesn't this require the MET to be programmed onto the DFCs?
>
>Cheers
>Christian
>
>
>This message and any attachments (the "message") is
>intended solely for the addressees and is confidential.
>If you receive this message in error, please delete it and
>immediately notify the sender. Any use not in accord with
>its purpose, any dissemination or disclosure, either whole
>or partial, is prohibited except formal approval. The internet
>can not guarantee the integrity of this message.
>BNP PARIBAS (and its subsidiaries) shall (will) not
>therefore be liable for the message if modified.
>
>**********************************************************************************************
>
>BNP Paribas Private Bank London Branch is authorised
>by CECEI & AMF and is regulated by the Financial Services
>Authority for the conduct of its investment business in
>the United Kingdom.
>
>BNP Paribas Securities Services London Branch is authorised
>by CECEI & AMF and is regulated by the Financial Services
>Authority for the conduct of its investment business in
>the United Kingdom.
>
>BNP Paribas Fund Services UK Limited is authorised and
>regulated by the Financial Services Authority
>
>_______________________________________________
>cisco-nsp mailing list  cisco-nsp at puck.nether.net
>https://puck.nether.net/mailman/listinfo/cisco-nsp
>archive at http://puck.nether.net/pipermail/cisco-nsp/



Tim Stevenson, tstevens at cisco.com
Routing & Switching CCIE #5561
Technical Marketing Engineer, Catalyst 6500
Cisco Systems, http://www.cisco.com
IP Phone: 408-526-6759
********************************************************
The contents of this message may be *Cisco Confidential*
and are intended for the specified recipients only.