[c-nsp] per user traffic shaping on 6509

[Tihomir Dragas]

Hi,

You have options to apply rate limiting during authorization phase via 
radius attribute. Radius attribute is:

cisco-avpair = lcp:interface-config=rate-limit output %{Rate-Limit-Up} 
%{Rate-Limit-Up} %{Rate-Limit-Up} conform-action transmit exceed-action 
transmit,

cisco-avpair = lcp:interface-config=rate-limit input %{Rate-Limit-Down} 
%{Rate-Limit-Down} %{Rate-Limit- Down} conform-action transmit exceed-action 
transmit

Best Regards,
Tiho

----- Original Message ----- 
From: "Cisco Boy" <firstccie at gmail.com>
To: "Cisco-nsp" <cisco-nsp at puck.nether.net>
Sent: Tuesday, September 12, 2006 7:03 AM
Subject: [c-nsp] per user traffic shaping on 6509


> Sorry guys,
> consider this drawing:
>
>
> Hi Guys,
>
> The below is the scenario: Its pretty much an ISP setup.
>
> PPPoE User------------Catalyst--6509-----InternetOUT
>                        |----------AAA Server
>                        |----------MAIL/webServer
>                        |----------7301
>
> _*
> The question is: *_
>
> Once PPPoE user is authenticated to AAA server, Is there any TRICK! to
> control the per user (1PPPoE session/user) bandwidth on the 6509?
> That perticular user/pppoe (with dynamic IP) should be able to
> transmitt/receive pre-defined bandwidth (say 512 - up/down).
>
> Is this feature supported on the 65xx series?
>
> Thanks
>
> CiscoBoy
>
>
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
>