[c-nsp] 7206 VXR size question

[Matt Addison]

The bandwidth points document allows you to only use 1 port of a 2 port FE PA or IO controller for 200 points.

________________________________

From: cisco-nsp-bounces at puck.nether.net on behalf of Robert Blayzor
Sent: Wed 9/20/2006 13:36
To: Eric Helm
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] 7206 VXR size question



Eric Helm wrote:
> How many ATM Port Adapters (PA-A3-OC3SMI) are supported on a single 7206
> VXR NPE-400 with 512MB DRAM? I need to put 3 of them in the box.
> This will terminate 1500 DSL Internet subscribers, 90% are 256kbps, so
> PPS or Mbps should not be an issue.


Chances are if you have an NPE-400 you have the dual FE IO controller.
Unless you upgraded an older box with one FE controller.

A two port IO controller takes 400 bandwidth points, so you can only put
TWO OC3 cards on the opposite PCI bus.

If you have a single FE you can put one OC3 on the even side and two on
the odd side, three total.

If you have an NPE-G1/G2 then you can put four OC3 cards, two on each bus.

--
Robert Blayzor, BOFH
INOC, LLC
rblayzor\@(inoc.net|gmail.com)
PGP: 0x66F90BFC @ http://pgp.mit.edu
Key fingerprint = 6296 F715 038B 44C1 2720  292A 8580 500E 66F9 0BFC

There are two ways to write error-free programs. Only the third one works.
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/