[c-nsp] %LINK-4-ERROR and %CDP-4-DUPLEX_MISMATCH
Bagosi Rómeó
Romeo.Bagosi at integris.hu
Tue Apr 3 05:27:09 EDT 2007
Hi all Experts!
I have the following problem:
We have two switch connected by fiber cable:
WS-C2960G-24TC-L:Gi0/21<<<<< >>>>> Fa1/4:WS-C2924M-XL
FIBER
The problem is, that the C2924 Switch sends the following messages in every minute:
Apr 3 08:11:33.112 MET-DST: %LINK-4-ERROR: FastEthernet1/4 is experiencing errors
On the C2960 I cannot change the duplex or the speed settings.
On the C2924 I've changed the duplex settings, but:
- If it's set to duplex auto or duplex full, then %CDP-4-DUPLEX_MISMATCH error on the C2960 Switch
- If it's set to duplex half, then %LINK-4-ERROR on the C2924 Switch
Why the newer Cisco Devices and IOS doesn't support the speed and duplex settings?
Does these errors highly affect the network performance?
Is there any solution for this problem?
Thank you in anticipation!
C2924# sh int fa1/4
FastEthernet1/4 is up, line protocol is up
Hardware is Fast Ethernet, address is 0004.9a20.63e0 (bia 0004.9a20.63e0)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 250/255, txload 7/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Half-duplex, 100Mb/s, 100BaseFX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:06, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 588000 bits/sec, 440 packets/sec
5 minute output rate 2890000 bits/sec, 530 packets/sec
1752297879 packets input, 4205642061 bytes
Received 6728883 broadcasts, 0 runts, 0 giants, 0 throttles
5814363 input errors, 5814363 CRC, 0 frame, 58583 overrun, 61143 ignored
0 watchdog, 1817612 multicast
0 input packets with dribble condition detected
2107649242 packets output, 3958607124 bytes, 12 underruns
12023160 output errors, 7511084 collisions, 8 interface resets
0 babbles, 12023160 late collision, 12054327 deferred
0 lost carrier, 0 no carrier
12 output buffer failures, 0 output buffers swapped out
C2960#sh int Gi0/21
GigabitEthernet0/21 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 0018.73ec.5b95 (bia 0018.73ec.5b95)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 252/255, txload 1/255, rxload 6/255
Encapsulation ARPA, loopback not set
Keepalive not set
Half-duplex, 100Mb/s, link type is auto, media type is 100BaseFX SFP
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:04, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 2735000 bits/sec, 519 packets/sec
5 minute output rate 599000 bits/sec, 440 packets/sec
1744270788 packets input, 3129573151 bytes, 0 no buffer
Received 61767996 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
11288249 input errors, 11288249 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 16264953 multicast, 0 pause input
0 input packets with dribble condition detected
1466543564 packets output, 2681409739 bytes, 0 underruns
0 output errors, 15260833 collisions, 1 interface resets
0 babbles, 6268873 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
More information about the cisco-nsp
mailing list