[c-nsp] E1 loop on WIC

[O S]

Hi all

I think I must missed something obvious.  I had hardloop plug in a WIC E1 port
and can not see the loop.  Some result on anther new router/WIC.  Here is my 
configuration.  Any help will be greatly appreciated.

OP

        WIC Slot 0:
        E1 (2 port) Multi-Flex Trunk WAN daughter card
        Hardware revision 1.0           Board revision B0
        Serial number     35450670      Part number    800-04479-04
        FRU Part Number     VWIC-2MFT-E1=
        Test history      0x0           RMA number     00-00-00
        Connector type    PCI
        EEPROM format version 1

the router is 
System image file is "flash:c3845-ipbase-mz.124-11.T.bin"

Cisco 3845 (revision 1.0) with 225280K/36864K bytes of memory.
Processor board ID FCZ1102710B
2 Gigabit Ethernet interfaces
4 Serial interfaces
2 Channelized E1/PRI ports

The configuration is
controller E1 0/0/1
 clock source internal
 channel-group 0 timeslots 1-31
 detect v54 channel-group 0

E1 0/0/1 is down.
  Applique type is Channelized E1 - balanced
  Far End Block Errors Detected
  Receiver has loss of signal.
  alarm-trigger is not set
  Version info Firmware: 20060623, FPGA: 20, spm_count = 0
  Framing is CRC4, Line Code is HDB3, Clock Source is Internal.
  CRC Threshold is 320. Reported from firmware  is 320.

Serial0/0/1:0 is down, line protocol is down
  Hardware is GT96K Serial







       
____________________________________________________________________________________
We won't tell. Get more on shows you hate to love 
(and love to hate): Yahoo! TV's Guilty Pleasures list.
http://tv.yahoo.com/collections/265