[c-nsp] sh Queue output ?

[Azher Amin]

Hi,

I have a 2Mb serial link with the main provider. However when i issue 
the following command, it says 'Available Bandwidth 1536 kilobits/sec'. 
Can some one plz explain why it is this behavior?

Regards
-Azher Amin

gw#sh queue serial 0/0/0:0
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 18488
  Queueing strategy: weighted fair
  Output queue: 0/1000/64/17894 (size/max total/threshold/drops)
     Conversations  0/93/256 (active/max active/max total)
     Reserved Conversations 0/0 (allocated/max allocated)
     Available Bandwidth 1536 kilobits/sec

gw#sh controllers E1 0/0/0
E1 0/0/0 is up.
  Applique type is Channelized E1 - balanced
  Description: 2Mbps IPL
  No alarms detected.
  alarm-trigger is not set
  Version info Firmware: 20041023, FPGA: 16, spm_count = 0
  Framing is UNFRAMED, Line Code is HDB3, Clock Source is Line.
  CRC Threshold is 320. Reported from firmware  is 320.
  Data in current interval (3 seconds elapsed):
     0 Line Code Violations, 0 Path Code Violations
     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs


Configurations:
---------------

controller E1 0/0/0
 channel-group 0 unframed
 description 2Mbps IPL

interface Serial0/0/0:0
 bandwidth 2048
 ip address 203.99.50.33 255.255.255.252
 ip nat outside
 ip virtual-reassembly



-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.