[c-nsp] Multiple T1 IMA / Channelized DS3

[Joe Freeman]

If they're dropping IMA T1's to an M13 mux on each end of the ChDS3, and
going into an IMA card on the router, then that will work.

The PA-MC-T3 cards and variants can't do ATM in any flavor, though.

Joe

On 8/28/07, OCOSA ListAcct <listacc at ocosa.com> wrote:
>
> Ok. I spoke with AT&T earlier they said that they have other customers
> taking some T1 IMAs over a channelized DS3 into the same router I was
> like how they said they would have a tech contact me I was ok. I thought
> maybe take the DS3 circuit into some sort of mux and split the signal
> from the IMA and send to a cross connect and then to the PA-A3-8T1IMA
> card....Can anyone shed some light here? Any help is appreciated!
>
> Otis
>
> Joe Freeman wrote:
> > PA-MC-T3 cards won't do IMA.
> >
> > That said... Does anyone have any suggestions for scaling NxDS0
> > circuits muxed to ChDS3 in a 7206 chassis beyond 12 DS3's?
> >
> > Joe
> >
> > On 8/28/07, *OCOSA ListAcct* <listacc at ocosa.com
> > <mailto:listacc at ocosa.com>> wrote:
> >
> >     Has anyone took a channelized DS3 circuit using a (PA-MC-T3) and
> >     place a
> >     T1 IMA circuit for dsl aggregation on that same circuit filling up
> >     four
> >     full T1 slots? Would this be a layer 2 local switching setup on the
> >     pa-mc-t3 card?
> >
> >     Otis
> >
> >
> >     _______________________________________________
> >     cisco-nsp mailing list  cisco-nsp at puck.nether.net
> >     <mailto:cisco-nsp at puck.nether.net>
> >     https://puck.nether.net/mailman/listinfo/cisco-nsp
> >     archive at http://puck.nether.net/pipermail/cisco-nsp/
> >
> >
>
>