[c-nsp] NM-16ESW Problem

Paul Stewart paul at paulstewart.org
Tue Dec 11 07:30:16 EST 2007


Hi folks..

Having a problem passing layer3 traffic via SVI on a NM-16ESW module and
stumped ;)

Cisco 3825 router with (2) NM-16ESW modules:

interface FastEthernet2/1
 description xxxxxxxxxxxxxxx
 switchport access vlan 30

interface Vlan30
 description xxxxxxxxxxxxxxxxxxx
 ip address xxx.xxx.xxx.153 255.255.255.248

VLAN exists in the VLAN Database ….

Can’t pass any traffic on this interface even if I connect my notebook
directly and try to ping the SVI interface:

FastEthernet2/1 is up, line protocol is up
  Hardware is Fast Ethernet, address is 0009.7c83.abac (bia 0009.7c83.abac)
  Description: xxxxxxxxxxxxxxxxxxx
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 100Mb/s
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:22, output never, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     227 packets input, 25986 bytes, 0 no buffer
     Received 127 broadcasts, 0 runts, 0 giants, 0 throttles
     30 input errors, 6 CRC, 4 frame, 0 overrun, 0 ignored
     0 input packets with dribble condition detected
     2 packets output, 162 bytes, 0 underruns
     15 output errors, 0 collisions, 2 interface resets
     9 unknown protocol drops
    0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier
     0 output buffer failures, 0 output buffers swapped out


Vlan30 is up, line protocol is up
  Hardware is EtherSVI, address is 001d.46c6.0540 (bia 001d.46c6.0540)
  Description: xxxxxxxxxxxxxxxxx
  Internet address is xxx.xxx.xxx.153/29
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:03, output never, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 235
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     63 packets input, 5456 bytes, 0 no buffer
     Received 63 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 1 interface resets
     0 unknown protocol drops
     0 output buffer failures, 0 output buffers swapped out


Any ideas?

Thanks,

Paul

No virus found in this outgoing message.
Checked by AVG Free Edition. 
Version: 7.5.503 / Virus Database: 269.16.17/1179 - Release Date: 12/9/2007
11:06 AM
 



More information about the cisco-nsp mailing list