[c-nsp] EoMPLS - redunancy?

[FAHAD ALI KHAN]

Well if any body in the list ever configure L2VPN Pseudowire Redundancy
Feature......than kindly share the sample configuration and practical
experience.

The document provided on Cisco Website is not dictating the whole picture
clearly.....!


On 1/31/07, Sean Watkins <sean at northrock.bm> wrote:
>
>
> Hi
>
> Looking more into the feature - L2VPN Pseudowire Redundancy - allowing
> for a  backup link in a EoMLPS Tunnel -
>
>
> http://www.cisco.com/en/US/products/sw/iosswrel/ps1829/products_feature_
> guide09186a0080606811.html
>
> Its supported on these platforms
>
> 1841
> 2801
> 2811
> 2821
> 3725
> 3745
> 3825
> 3845
> 7200
> 7200-NPE-G2
> 7304-NPE-G100
> ...
> 10000-PRE3
>
> But no 3750 metro support - anyone on this list off or on, know how to
> get this feature pushed into the 3750 metro? Its odd that a 1841 has it,
> but not a 3750 Metro? Or are there any other non-hackish ways of
> building backup paths into a EoMLPS tunnel?
>
>
>
> --
> Sean Watkins
> North Rock Communications
> Phone: 441-540-4102
>
>
> > -----Original Message-----
> > From: Robert Crowe [mailto:rocrowe at cisco.com]
> > Sent: Thursday, January 18, 2007 1:04 PM
> > To: Sean Watkins; cisco-nsp at puck.nether.net
> > Cc: rocrowe at cisco.com
> > Subject: RE: [c-nsp] EoMPLS - redunancy?
> >
> > http://www.cisco.com/univercd/cc/td/doc/product/software/ios12
> > 0/120newft/120
> > limit/120s/120s31/fspseudo.htm
> >
> >
> > Rob
> >
> >
> > -----Original Message-----
> > From: cisco-nsp-bounces at puck.nether.net
> > [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Sean Watkins
> > Sent: Thursday, January 18, 2007 11:43 AM
> > To: cisco-nsp at puck.nether.net
> > Subject: [c-nsp] EoMPLS - redunancy?
> >
> > Hi,
> >
> > If I build a EoMLPLS tunnel from say a 3750-M to 3750-3750, I
> > basically build commands like this:
> >
> > 3750-M A
> >
> > !
> > Int loopback0
> > Ip address 1.2.1.3 255.255.255.255
> >
> > interface FastEthernet1/0/1
> >  no switchport
> >  no ip address
> >  no cdp enable
> >  xconnect 1.2.1.4 1000 encapsulation mpls  no clns route-cache
> >
> >
> > 3750-M B
> > !
> > Int loopback0
> > Ip address 1.2.1.4 255.255.255.255
> >
> > interface FastEthernet1/0/1
> >  no switchport
> >  no ip address
> >  no cdp enable
> >  xconnect 1.2.1.3 1000 encapsulation mpls  no clns route-cache
> >
> >
> > Which works great.
> >
> >
> > If I wanted to replace the 3750-B, with a 2 3750s for
> > redundancy, how would that work? Is there anything in EoMPLS
> > to specify say a second peer?
> >
> > Ie
> >
> > Xconnect 1.2.1.3 1000 encapsulation mpls backup 1.2.1.5?
> >
> > Sean
> >
> >
> >
> >
> >
> >
> >
> > --
> > Sean Watkins
> > North Rock Communications
> > Phone: 441-540-4102
> >
> >
> > _______________________________________________
> > cisco-nsp mailing list  cisco-nsp at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-nsp
> > archive at http://puck.nether.net/pipermail/cisco-nsp/
> >
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>