[c-nsp] rate-limit input on 4700

[Jordan Tikvesanski]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi,

I have strange problem (as problems always are).

On Ethernet0 interface on Cisco 4700 are applied rate-limits (in and
out). show run int e0 shows them both.

sh run int e0
Building configuration...

Current configuration:
!
interface Ethernet0
 ip address ...
 no ip directed-broadcast
 rate-limit input 1024000 128000 256000 conform-action transmit
exceed-action drop
 rate-limit output 1024000 128000 256000 conform-action transmit
exceed-action drop
 no ip mroute-cache
 media-type 10BaseT
end

But...

sh int e0 rate-limit
Ethernet0
  Input
    matches: all traffic
      params:  1024000 bps, 128000 limit, 256000 extended limit
      conformed 0 packets, 0 bytes; action: transmit
      exceeded 0 packets, 0 bytes; action: drop
      last packet: 152903992ms ago, current burst: 0 bytes
      last cleared 00:04:52 ago, conformed 0 bps, exceeded 0 bps
  Output
    matches: all traffic
      params:  1024000 bps, 128000 limit, 256000 extended limit
      conformed 30422 packets, 28265012 bytes; action: transmit
      exceeded 195 packets, 209540 bytes; action: drop
      last packet: 12ms ago, current burst: 1058 bytes
      last cleared 00:04:52 ago, conformed 771000 bps, exceeded 5000 bps

shows that packets on input are not policed (last packet: 152903992ms ago).

IOS version is 12.0(28d) (due to RAM/flash limitations I'm not able to
upgrade) and the ethernet0 is on 6 port ethernet module NP-6E.

Any suggestions would be welcome.

Thanks

- --
Jordan Tikvesanski, mailto:jtikves at sonet.com.mk
Sonet Network Solution
ul. Partizanski odredi 72a, 1000 Skopje, Macedonia
tel: +389 2 3072375
fax: +389 2 3072757
http://www.sonet.com.mk
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.5 (MingW32)

iD8DBQFF1aq4kg6RSDBFerYRAm8yAKCtqL/FBDM4jdClncxYqgz90QTa3QCgpETx
Ccqun/p4MFzsoNzDPmpXBsg=
=SXE4
-----END PGP SIGNATURE-----