[c-nsp] EoMPLS - redunancy?

[Sean Watkins]

Hi

Looking more into the feature - L2VPN Pseudowire Redundancy - allowing
for a  backup link in a EoMLPS Tunnel -


http://www.cisco.com/en/US/products/sw/iosswrel/ps1829/products_feature_
guide09186a0080606811.html

Its supported on these platforms

1841
2801
2811
2821
3725
3745
3825
3845
7200
7200-NPE-G2
7304-NPE-G100
...
10000-PRE3

But no 3750 metro support - anyone on this list off or on, know how to
get this feature pushed into the 3750 metro? Its odd that a 1841 has it,
but not a 3750 Metro? Or are there any other non-hackish ways of
building backup paths into a EoMLPS tunnel?



--
Sean Watkins
North Rock Communications
Phone: 441-540-4102
  

> -----Original Message-----
> From: Robert Crowe [mailto:rocrowe at cisco.com] 
> Sent: Thursday, January 18, 2007 1:04 PM
> To: Sean Watkins; cisco-nsp at puck.nether.net
> Cc: rocrowe at cisco.com
> Subject: RE: [c-nsp] EoMPLS - redunancy?
> 
> http://www.cisco.com/univercd/cc/td/doc/product/software/ios12
> 0/120newft/120
> limit/120s/120s31/fspseudo.htm 
> 
> 
> Rob
> 
> 
> -----Original Message-----
> From: cisco-nsp-bounces at puck.nether.net
> [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Sean Watkins
> Sent: Thursday, January 18, 2007 11:43 AM
> To: cisco-nsp at puck.nether.net
> Subject: [c-nsp] EoMPLS - redunancy?
> 
> Hi,
> 
> If I build a EoMLPLS tunnel from say a 3750-M to 3750-3750, I 
> basically build commands like this:
> 
> 3750-M A
> 
> !
> Int loopback0
> Ip address 1.2.1.3 255.255.255.255
> 
> interface FastEthernet1/0/1
>  no switchport
>  no ip address
>  no cdp enable
>  xconnect 1.2.1.4 1000 encapsulation mpls  no clns route-cache
> 
> 
> 3750-M B
> !
> Int loopback0
> Ip address 1.2.1.4 255.255.255.255
> 
> interface FastEthernet1/0/1
>  no switchport
>  no ip address
>  no cdp enable
>  xconnect 1.2.1.3 1000 encapsulation mpls  no clns route-cache
> 
> 
> Which works great.
> 
> 
> If I wanted to replace the 3750-B, with a 2 3750s for 
> redundancy, how would that work? Is there anything in EoMPLS 
> to specify say a second peer?
> 
> Ie
> 
> Xconnect 1.2.1.3 1000 encapsulation mpls backup 1.2.1.5?
> 
> Sean
> 
> 
> 
> 
> 
> 
> 
> --
> Sean Watkins
> North Rock Communications
> Phone: 441-540-4102
>  
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net 
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>