[c-nsp] Netflow: 7600, egress

[Dmitry Kiselev]

Hello!

On my 7600 test box with RSP720 I failed to do egress netflow.
Here is config snapshot:

mls flow ip interface-full

interface GigabitEthernet1/25
 ip address XXX.YYY.17.2 255.255.255.252
 ip flow ingress
 ip flow egress
!
interface GigabitEthernet1/26
 ip address XXX.YYY.16.2 255.255.255.252
!


When I send pings between two routers connected to g1/25 and g1/26
I see only g1/25 ingress flow records:


Router-XXX.YYY.17.1#ping XXX.YYY.16.1

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to XXX.YYY.16.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/9 ms


7600-RSP720#sh mls netflow ip dest XXX.YYY.16.1
Displaying Netflow entries in Supervisor Earl
DstIP           SrcIP           Prot:SrcPort:DstPort  Src i/f          :AdjPtr
-----------------------------------------------------------------------------
Pkts         Bytes         Age   LastSeen  Attributes
---------------------------------------------------
XXX.YYY.16.1     XXX.YYY.17.1     icmp:8      :0        Gi1/25           :0x0
5            500           1     14:23:37   L3 - Dynamic

7600-RSP-720#sh mls netflow ip sour XXX.YYY.16.1
Displaying Netflow entries in Supervisor Earl
DstIP           SrcIP           Prot:SrcPort:DstPort  Src i/f          :AdjPtr
-----------------------------------------------------------------------------
Pkts         Bytes         Age   LastSeen  Attributes
---------------------------------------------------

7600-RSP-720#


In my config I can't enable igress netflow on both interfaces.
Moreover, in production config physical interfaces need to be
replaced with SVIs.  Is it possible to see engress hardware
switched traffic?

Ahh, in slot 1 6748-GE card installed and SRB1 IOS used.

-- 
Dmitry Kiselev