[c-nsp] Netflow: 7600, egress

[alexey]

Hello!
Dmitry, where have you find anything about egress NetFlow on 7600? :)
I am reading config guide attentively
http://www.cisco.com/en/US/products/hw/routers/ps368/products_configuration_guide_chapter09186a0080699369.html#wp1078217
but no nothing about egress netflow!

2007/7/4, Dmitry Kiselev <dmitry at dmitry.net>:
>
> Hello!
>
> On my 7600 test box with RSP720 I failed to do egress netflow.
> Here is config snapshot:
>
> mls flow ip interface-full
>
> interface GigabitEthernet1/25
> ip address XXX.YYY.17.2 255.255.255.252
> ip flow ingress
> ip flow egress
> !
> interface GigabitEthernet1/26
> ip address XXX.YYY.16.2 255.255.255.252
> !
>
>
> When I send pings between two routers connected to g1/25 and g1/26
> I see only g1/25 ingress flow records:
>
>
> Router-XXX.YYY.17.1#ping XXX.YYY.16.1
>
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to XXX.YYY.16.1, timeout is 2 seconds:
> !!!!!
> Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/9 ms
>
>
> 7600-RSP720#sh mls netflow ip dest XXX.YYY.16.1
> Displaying Netflow entries in Supervisor Earl
> DstIP           SrcIP           Prot:SrcPort:DstPort  Src
> i/f          :AdjPtr
>
> -----------------------------------------------------------------------------
> Pkts         Bytes         Age   LastSeen  Attributes
> ---------------------------------------------------
> XXX.YYY.16.1     XXX.YYY.17.1     icmp:8      :0        Gi1/25
> :0x0
> 5            500           1     14:23:37   L3 - Dynamic
>
> 7600-RSP-720#sh mls netflow ip sour XXX.YYY.16.1
> Displaying Netflow entries in Supervisor Earl
> DstIP           SrcIP           Prot:SrcPort:DstPort  Src
> i/f          :AdjPtr
>
> -----------------------------------------------------------------------------
> Pkts         Bytes         Age   LastSeen  Attributes
> ---------------------------------------------------
>
> 7600-RSP-720#
>
>
> In my config I can't enable igress netflow on both interfaces.
> Moreover, in production config physical interfaces need to be
> replaced with SVIs.  Is it possible to see engress hardware
> switched traffic?
>
> Ahh, in slot 1 6748-GE card installed and SRB1 IOS used.
>
> --
> Dmitry Kiselev
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>