[c-nsp] QoS RSP720

[Rodney Dunn]

If you want a fancy qos policy on an interface apply it
via an MQC policy (policy-map and class-map combination).

You didn't explain how you are trying to configure it.

No all MQC configurations are supported on all hw forwarding
platforms.

Rodney


On Tue, Jul 10, 2007 at 08:52:24PM +0200, coueffe charly wrote:
> Hi,
> 
> I'm using a supervisor card RSP720. I'll use the QoS, but the command
> fair-queue is not implementing with this IOS
> (7600rsp72043-adventerprisek9-mz.122-33.SRB1.bin).
> 
> If I watch the queueing strategy, It's the WWR and with the command "sh
> int gi2/1" it's fifo. It's normal ?
> 
> #show queueing interface gigabitEthernet 2/1
> Interface GigabitEthernet2/1 queueing strategy:  Weighted Round-Robin
>   Port QoS is enabled
>   Trust state: trust COS
>   Extend trust state: not trusted [COS = 0]
>   Default COS is 0
>     Queueing Mode In Tx direction: mode-cos
>     Transmit queues [type = 1p3q8t]:
>     Queue Id    Scheduling  Num of thresholds
>   
> GigabitEthernet2/1 is down, line protocol is down (notconnect)
>   Hardware is C6k 1000Mb 802.3, address is 001b.0caf.37d8 (bia
> 001b.0caf.37d8)
>   Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 
>   Queueing strategy: fifo
> 
> Regards,
> 
> Charly
> 
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/