[c-nsp] 6500/7600 boot issues

[David Prall]

That's it. I can't find my notes on this one. I think this was mentioned
here previously as well. 

David

--
http://dcp.dcptech.com
  

> -----Original Message-----
> From: Jon Lewis [mailto:jlewis at lewis.org] 
> Sent: Thursday, June 07, 2007 3:59 PM
> To: David Prall
> Cc: cisco-nsp at puck.nether.net
> Subject: RE: [c-nsp] 6500/7600 boot issues
> 
> On Thu, 7 Jun 2007, David Prall wrote:
> 
> > You just set the config register, then confirm with the 
> remote commands.
> > Some where in the mix it didn't synchronize between the 
> two. Had this 
> > problem on a 6500, spent 4 hours trying to figure out why 
> it was happening.
> > I now confirm and verify.
> 
> ok...so I guess you do that on the msfc, and it's supposed to 
> sync with the sup?  It looks like that worked.
> 
> # rem com sw sh ver | inc register
> Configuration register is 0x2142 (will be 0x2102 at next reload)
> 
> Unfortunately, I won't know if that's cleared the problem 
> until Tuesday night.
> 
> ----------------------------------------------------------------------
>   Jon Lewis                   |  I route
>   Senior Network Engineer     |  therefore you are
>   Atlantic Net                |
> _________ http://www.lewis.org/~jlewis/pgp for PGP public 
> key_________