[c-nsp] Solid L2 switch - 2948G or 3548-XL-EN?

Gary Stanley gary at velocity-servers.net
Sun Jun 24 07:21:03 EDT 2007


At 05:23 AM 6/24/2007, Gert Doering wrote:
>Hi,
>
>On Sat, Jun 23, 2007 at 03:47:01PM -0400, Lamar Owen wrote:
> > I was mostly curious if someone had had issues with them, other than these
> > documented limitations.
>
>Some of the worst problems we experienced:
>
>  - switch suddenly stopping to switch any traffic, requiring a power cylce
>    (we had the device RMAed, but the second one did it as well).  TAC never
>    found the reason.
>
>  - when you applied ACLs to the GE ports, and the ACL exceeded a certain
>    length and could not fit to the TCAM anymore, the switch *SILENTLY*
>    removes the ACL from the interface (it prints a warning to CONSOLE,
>    but not to vty, syslog, or anywhere else where you might actually
>    notice).  TAC claimed "this cannot be changed".
>

We've had that same problems as you in the past, it was a curious 
learning experience.
   



More information about the cisco-nsp mailing list