[c-nsp] problem with creating routed interface on FWSM

[Joann Deng]

Hi,

I am having problem with creating an interface on
FWSM. I am trying to add vlan 630 into FWSM.
The version I am using is 3.1(5), and following shows
what I have configured:

On switch:

swp01#sh fir mod
Module Vlan-groups
------ -----------
  04   1,2,4,51
  05   2,3,5

swp01#sh fir vlan-g 3
Group    Created by      vlans
-----    ----------      -----
    3          FWSM     
507,510,520,530,540,610,620,630,640,650,800

On FWSM:

fwp02p# sh run int vlan630
!
interface Vlan630
 nameif Auth
 security-level 85
 ip address 209.114.69.129 255.255.255.224 standby
209.114.69.130 
fwp02p# 

But the interface is always down&down even I did "no
sh":

fwp02p# sh int vlan630
Interface Vlan630 "Auth", is down, line protocol is
down
  Hardware is EtherSVI
        MAC address 0019.06ed.9600, MTU 1500
        IP address 209.114.69.129, subnet mask
255.255.255.224
  Traffic Statistics for "Auth":
        0 packets input, 0 bytes
        0 packets output, 0 bytes
        0 packets dropped

So I run "sh ip address", unlike other interface,
Vlan630 is shown as "manual", any idea what caused
this?

System IP Addresses:
Interface                Name                   IP
address      Subnet mask     Method 
         209.114.64.1    255.255.255.0   CONFIG
Vlan610                  Mon_GR                
x.114.68.1    255.255.255.128 CONFIG
Vlan620                  Mon_BR                
x.114.68.129  255.255.255.128 CONFIG
Vlan630                  Auth                  
x.114.69.129  255.255.255.224 manual

Thanks in anticipation,

Joann


       
____________________________________________________________________________________
Get the Yahoo! toolbar and be alerted to new email wherever you're surfing.
http://new.toolbar.yahoo.com/toolbar/features/mail/index.php