[c-nsp] SUP7203BXL - show cat traf doesnt work ?

[Phil Rosenthal]

This generally indicates that you have a Sup720-base that was  
upgraded to Sup720-3bxl.  The hardware just does not support "show cat".

IIRC from the Sup720, only the packages that came from the factory as  
Sup720-3BXL have this counter.

--Phil

On May 1, 2007, at 9:23 AM, John R wrote:

> Hi
>
> We have a few 6503-E with SUP720-3BXL.
>
> They are all running 12.2(18)SXF4 ADVIPSERVICES
>
> One of them seems unwilling to show anything for traffic meter.
>
> SOV#show cat t
>  This Supervisor hardware revision has no support for traffic meter  
> feature.
>
>
> SOV#show mod 1
> Mod Ports Card Type                              Model               
> Serial
> No.
> --- ----- -------------------------------------- ------------------
> -----------
>   1    2  Supervisor Engine 720 (Active)         WS-SUP720-3BXL
> SAD10030A8K
>
> Mod MAC addresses                       Hw    Fw           Sw
> Status
> --- ---------------------------------- ------ ------------  
> ------------
> -------
>   1  000d.2910.3f24 to 000d.2910.3f27   3.2   8.1(3)       12.2(18) 
> SXF4 Ok
>
> Mod  Sub-Module                  Model              Serial       Hw
> Status
> ---- --------------------------- ------------------ -----------  
> -------
> -------
>   1  Policy Feature Card 3       WS-F6K-PFC3BXL     SAD1013C01W   
> 1.3    Ok
>   1  MSFC3 Daughterboard         WS-SUP720          SAD1014DLJH   
> 2.1    Ok
>
> Mod  Online Diag Status
> ---- -------------------
>   1  Pass
>
> As far as im concerned anything with a PFC3B/BXL should support  
> traffic
> meters... Or did I miss something somewhere :)
>
> Thanks!
>
> john
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/