[c-nsp] routing v6 on a bvi?

[matthew zeier]

I have a 3845 running 12.4(9)T1 (advipservicesk9-mz if it matters) and 
am trying to get ipv6 running on a bvi:


interface BVI2
  ip address 10.250.2.254 255.255.255.0
  ip access-group into-corp out
  ip nat inside
  ip inspect Inside in
  ip virtual-reassembly
  ipv6 address 2001:470:1F01:3521:1981:200:0:1/96
  ipv6 enable

bridge 2 protocol ieee
bridge 2 route ip

I can source ping packets from that interface to remote sites but I 
can't ping locally attached machines on either their link-local 
addresses or manually configured (auto-configuration isn't working 
either).  On other routers (6500s) I can ping link-local addresses just 
fine so I should expect that to work here too.

I can't tell if my config's wrong or it's a bvi & v6 support issue. 
Anyone know?