[c-nsp] single interface multiple VRF

[Masood Ahmad Shah]

I know if you use VRF-Lite you binds logical interfaces to a VRF (normally
one WAN-interface and one LAN-interface). If there is only one WAN-link, it
must be divided into sub-interfaces (with F/R, channel-groups, Vlans etc).
The same applies to single LAN-ports. Is it correct?

How exactly you guys use VRF when you bound to terminate all of your client
on single or two interfaces along with GRE tunnel IP Source and Destination
VRF membership. 

Regards,
Masood Ahmad Shah

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Masood Ahmad Shah
Sent: Friday, October 05, 2007 3:01 AM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] single interface multiple VRF


Is it Possible to have 2 or more VRF tables existing on one single Interface
Eth/Serial. If the answer is yes, how do you guys do that. 

Regards,
Masood Ahmad Shah


_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/