[c-nsp] Multiple T1 IMA / Channelized DS3

[OCOSA ListAcct]

Thanks seems to be cheaper than the Adtran MX2800 setup....

Otis



Ted Mittelstaedt wrote:
> Hi,
>
>   Telco Systems sells boxes that will break out a channelized DS3 into
> T1s.  You can get them off Ebay for about $500-$800.  That is how we
> handle our channelized DS3s.  We break them out with the Telco systems
> boxes then run the T1's through a DSU bank then into PA-8T serial cards
> with octopus cable.  The Telco systems boxes, DSU bank and 8 port serial
> cars grand total is far cheaper than getting channelized DS3 cards for
> the 7206 and you also could use this to break a DS3 down into some
> IMA channels that run into your PA-A3-8T1IMA card and others that run
> into a standard T1 card.
>
> Ted
>
>   
>> -----Original Message-----
>> From: cisco-nsp-bounces at puck.nether.net
>> [mailto:cisco-nsp-bounces at puck.nether.net]On Behalf Of OCOSA ListAcct
>> Sent: Tuesday, August 28, 2007 7:56 PM
>> To: Joe Freeman
>> Cc: cisco-nsp at puck.nether.net
>> Subject: Re: [c-nsp] Multiple T1 IMA / Channelized DS3
>>
>>
>> Ok. I spoke with AT&T earlier they said that they have other customers 
>> taking some T1 IMAs over a channelized DS3 into the same router I was 
>> like how they said they would have a tech contact me I was ok. I thought 
>> maybe take the DS3 circuit into some sort of mux and split the signal 
>> from the IMA and send to a cross connect and then to the PA-A3-8T1IMA 
>> card....Can anyone shed some light here? Any help is appreciated!
>>
>> Otis
>>
>> Joe Freeman wrote:
>>     
>>> PA-MC-T3 cards won't do IMA.
>>>
>>> That said... Does anyone have any suggestions for scaling NxDS0 
>>> circuits muxed to ChDS3 in a 7206 chassis beyond 12 DS3's?
>>>
>>> Joe
>>>
>>> On 8/28/07, *OCOSA ListAcct* <listacc at ocosa.com 
>>> <mailto:listacc at ocosa.com>> wrote:
>>>
>>>     Has anyone took a channelized DS3 circuit using a (PA-MC-T3) and
>>>     place a
>>>     T1 IMA circuit for dsl aggregation on that same circuit filling up
>>>     four
>>>     full T1 slots? Would this be a layer 2 local switching setup on the
>>>     pa-mc-t3 card?
>>>
>>>     Otis
>>>
>>>
>>>     _______________________________________________
>>>     cisco-nsp mailing list  cisco-nsp at puck.nether.net
>>>     <mailto:cisco-nsp at puck.nether.net>
>>>     https://puck.nether.net/mailman/listinfo/cisco-nsp
>>>     archive at http://puck.nether.net/pipermail/cisco-nsp/
>>>
>>>
>>>       
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>
>>