[c-nsp] 6500 not exporting layer 2 netflow data

[Peter Rathlev]

On Tue, 2008-04-29 at 18:56 +0300, Tassos Chatzithomaoglou wrote: 
> If i understand correctly, you're doing netflow for bridged IP traffic.
> 
> If yes, do you have a a corresponding VLAN interface with an IP address
>  as the one you're gathering netflow data from?

Exactly. The docs say about the "ip flow export layer2-switched ..."
command:

"Before you use this command on Catalyst 6500 Series Switches that are
configured with Supervisor Engine 720, you must ensure that a
corresponding VLAN interface is available and has a valid IP address."

From:
Catalyst 6500/6000 Switches NetFlow Configuration and Troubleshooting
http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a0080721701.shtml#switched
http://tinyurl.com/5sl3tq

But hey, if that is it, then why didn't TAC point it out? ;-)

Regards,
Peter