[c-nsp] 6500 not exporting layer 2 netflow data

[Jeff Fitzwater]

Oops I misspoke ont the VLAN-BASED.  That is only need for QOS  
microflow policing.   The problem we had is that QOS (microflow  
policing ) and NDE are exclusive.  One or the other.

Then again CISCO changes how it works every release.


Good luck.



Jeff Fitzwater


On Apr 29, 2008, at 12:33 PM, Peter Rathlev wrote:

> On Tue, 2008-04-29 at 18:56 +0300, Tassos Chatzithomaoglou wrote:
>> If i understand correctly, you're doing netflow for bridged IP  
>> traffic.
>>
>> If yes, do you have a a corresponding VLAN interface with an IP  
>> address
>> as the one you're gathering netflow data from?
>
> Exactly. The docs say about the "ip flow export layer2-switched ..."
> command:
>
> "Before you use this command on Catalyst 6500 Series Switches that are
> configured with Supervisor Engine 720, you must ensure that a
> corresponding VLAN interface is available and has a valid IP address."
>
> From:
> Catalyst 6500/6000 Switches NetFlow Configuration and Troubleshooting
> http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a0080721701.shtml#switched
> http://tinyurl.com/5sl3tq
>
> But hey, if that is it, then why didn't TAC point it out? ;-)
>
> Regards,
> Peter
>
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/