[c-nsp] BFD aware VRF

[Aaron]

Why do you need bfd on a serial interface? Seems like a waste of CPU and BW.

On Feb 4, 2008 1:12 PM, Luan Nguyen <luan.m.nguyen at gmail.com> wrote:

> I have bgp running between PE and CE.
> So on the PE, you do:
> router bgp xxxx
> address-family ipv4 vrf whatever
> neighbor y.y.y.y fall-over bfd
> Do the same for the CE under bgp.
> Then on the link between CE and PE, configured the bfd interval...etc.
>  That
> should work.
>
> The problem is my CE is a 1841 with a Channelized T1/PRI port and even
> with
> the latest 12.4.15T3, i can't put the bfd command under the serial
> interface!  Without interface level bfd command, bfd won't work.  Hello?
> I did try with an ethernet link between PE and CE, and bfd config looks
> good.
>
> -lmn
>
>
> On Feb 4, 2008 11:47 AM, Vikas Sharma <vikassharmas at gmail.com> wrote:
>
> > Hi,
> >
> > Anyone have configured VRF aware BFD? If yes pls let me know how?
> >
> > Regards
> > Vikas Sharma
> > _______________________________________________
> > cisco-nsp mailing list  cisco-nsp at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-nsp
> > archive at http://puck.nether.net/pipermail/cisco-nsp/
> >
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>