[c-nsp] Policer on Layer 2

[alaerte.vidali at nsn.com]

Hi,

Is there any hidden command to "better monitor" policer applied to layer
2 interface?

sh run int gi 3/6
Building configuration...

Current configuration : 239 bytes
!
interface GigabitEthernet3/6
 switchport
 switchport trunk encapsulation dot1q
 switchport mode trunk
 switchport nonegotiate
 speed 100
 duplex full
 service-policy input l2policer
end

sh policy-map interface gi 3/6

 GigabitEthernet3/6

  Service-policy input: l2policer

    class-map: l2policer (match-all)
      Match: access-group 122
      police :
        50000000 bps 1562000 limit 1562000 extended limit
      Earl in slot 5 :
        66 bytes
        5 minute offered rate 0 bps
        aggregate-forwarded 66 bytes action: transmit
        exceeded 0 bytes action: drop
        aggregate-forward 0 bps exceed 0 bps

    Class-map: class-default (match-any)
      0 packets, 0 bytes
      5 minute offered rate 0 bps, drop rate 0 bps
      Match: any
        0 packets, 0 bytes
        5 minute rate 0 bps

sh mls qos ip gigabitEthernet 3/6
   [In] Policy map is l2policer   [Out] Default.
 QoS Summary [IPv4]:      (* - shared aggregates, Mod - switch module)

      Int Mod Dir  Class-map DSCP  Agg  Trust Fl   AgForward-By
AgPoliced-By
                                   Id         Id
------------------------------------------------------------------------
-------
     Gi3/6  5  In  l2policer    0   49   dscp  0             66
0

sh mls qos ip gigabitEthernet 3/6
   [In] Policy map is l2policer   [Out] Default.
 QoS Summary [IPv4]:      (* - shared aggregates, Mod - switch module)

      Int Mod Dir  Class-map DSCP  Agg  Trust Fl   AgForward-By
AgPoliced-By
                                   Id         Id
------------------------------------------------------------------------
-------
     Gi3/6  5  In  l2policer    0   49   dscp  0             66
0


Tks,
Alaerte