[c-nsp] Rate-limiting traffic on 3500

[Tassos Chatzithomaoglou]

I don't think you can do "Per-Port Per-VLAN QoS" on 3550 or "VLAN-Based QoS" on 3560 on the egress 
direction. Just on ingress.

--
Tassos


Michael Malitsky wrote on 22/1/2008 2:25 πμ:
> Hello,
> 
> I am trying to figure out a way to set up some traffic limiters.
> Specific situation is: I have several VLANs in a 802.1q trunk on one
> port.  I need to control the _outbound_ traffic rate with a different
> CIR for each VLAN.  Traffic-shaping would be nice, but I don't think
> it's supported.  I'll settle for policing or even CAR, but so far
> haven't been able to figure it out.  I need this done on several
> switches, all are either 3550 or 3560 models.  
> Any suggestions appreciated.
> 
> If this can't be done, what's the minimum level of hardware necessary?
> 
> 
> Thanks,
> Michael Malitsky
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>