[c-nsp] Cisco WIC-1DSU-T1-V2 + 2811 + 12.4(11)T ??

[Jay Hennigan]

gagandeep singh wrote:
> Hi
> I have purchsed 1841 with same wic module .Is this below config work for 
> point to point T1 connection.
> 
> interface Serial0/0
> 
>  ip address 
> 
>  service-module t1 framing esf
> 
>  service-module t1 linecode b8zs
> 
>  service-module t1 timeslots 1-12 speed 64

Only if you are using just half of the T1 for data and you have the same 
timeslots on both ends.  Otherwise you want:

  service-module t1 timeslots 1-24 speed 64   (which is the default).

Also, on a point-to-point circuit depending on the carrier you may need 
to put:

  service-module t1 clock source internal

on ONE (not both) end of the circuit.

--
Jay Hennigan - CCIE #7880 - Network Engineering - jay at impulse.net
Impulse Internet Service  -  http://www.impulse.net/
Your local telephone and internet company - 805 884-6323 - WB6RDV