[c-nsp] Juniper - Cisco Catalyst Fast Ether Channel Load Balancing

hjan hjan at libero.it
Fri Jan 25 12:42:39 EST 2008



a. rahman isnaini r.sutan ha scritto:
> Hi Gian,
> 
> Both direction, output/input direction.
> And currently working on two ports.
> 
> Is there any specific additional commands on catalyst except belows :

With a cat 2950 you can olny do lb with source or dest mac-address.
So with a few destination, or single if it'a router, below the juniper, 
traffic will be quite umbalanced, all traffic sent by a source will 
always follow one channel path.
In this scenario src-mac balancing could help, but you haven't cleared 
network topology, so I can only guess.

Gian




More information about the cisco-nsp mailing list