[c-nsp] c7600 and VPLS

[Luan Nguyen]

Anyone knows when can the 7200VXR support VPLS?

thanks.

-lmn

On Jan 29, 2008 9:22 AM, Dennis Dubbelman <Dennis at winitu.com> wrote:

> For supporting VPLS on a 7600, OSM or ES20 linecards are needed on the
> Core facing interfacces. Those cards will handle the label push and pop
> for SVI based interfaces.
>
> You can use your defined hardware as a MPLS Access node and terminate
> your PW on a VPLS based 7600 router. This router must terminate the
> incoming PW's over a OSM or ES20 linecard.
>
> Cheers,,
> Dennis Dubbelman
>
> -----Original Message-----
> From: cisco-nsp-bounces at puck.nether.net
> [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of MKS
> Sent: dinsdag 29 januari 2008 15:02
> To: cisco-nsp at puck.nether.net
> Subject: [c-nsp] c7600 and VPLS
>
> Hi
>
> I'm a bit confused about hardware support for VPLS and cisco 7600.
>
> If I have only LAN cards e.g. 6724 customer facing and 6704 core facing
> does that mean that I have no VPLS support or just not H-VPLS ?
>
> Can I run some topology of VPLS with only LAN cards (full mesh,
> hub-spoke, partial mesh).
>
> Regards
> MKS
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>