[c-nsp] fabric switching enable

[Pham, Loc]

   How can I identify whether our module is switched on mix mode and how
to change it ? any gotcha ?

 

xxx#sh fab sw mo all

Module Slot     Switching Mode

    1                      Bus

    2                      Bus

    3                      Bus

 

XXX#sh fab sta

 slot    channel      speed    module               fabric

                               status               status

    1          0        20G        OK                   OK

 

XXX#sh module

Mod Ports Card Type                              Model
Serial No.

--- ----- -------------------------------------- ------------------
-----------

  1    2  Supervisor Engine 720 (Active)         WS-SUP720-3B
SAL...

  2   16  SFM-capable 16 port 1000mb GBIC        WS-X6516-GBIC      ...

  3   48  48 port 10/100/1000mb EtherModule      WS-X6148-GE-TX
SAL...

 

Mod MAC addresses                       Hw    Fw           Sw
Status

--- ---------------------------------- ------ ------------ ------------
-------

  1  ccc to 0016.c85e.40af   5.3   8.4(2)       12.2(18)SXF1 Ok

  2  cc00d0.c0d6.29e4 to 00d0.c0d6.29f3   3.0   6.1(3)
8.5(0.46)RFW Ok

  3  001accc6d0 to 001a.6d4a.c6ff   7.1   7.2(1)       8.5(0.46)RFW Ok

 

Mod  Sub-Module                  Model              Serial       Hw
Status 

---- --------------------------- ------------------ ----------- -------
-------

  1  Policy Feature Card 3       WS-F6K-PFC3B       SAL1ccc  2.3    Ok

  1  MSFC3 Daughterboard         WS-SUP720          SAL1ccc  2.6    Ok

 

Mod  Online Diag Status 

---- -------------------

  1  Pass

  2  Pass

  3  Pas

 

 

Regards,

Loc Pham, CCIE # 17030 - Sr. Network Staff, 

IT Network Architecture & Security, UCSF Medical Center

Office 415-353-4492