[c-nsp] 7204 viking flash

[Mateusz Błaszczyk]

Ibrahim,

>  I'm using viking flash Cisco router 7204 when I formatted disk0: it's done but when i tried to format Slot0: whech holds the flash it gave me this output: %Error formatting slot0 (Unspecified error).
>  even when i'm trying to access it by dir slot0: it gives me error device not ready
>

some pcmcia based cards aare referred as disk0 some slot0. If your
card is disk0 then you can not referred to it as slot0. As far as I
understand the process that are different ways to access the physical
drive.
So the card formatted as disk0 should be used like this
eg.
copy tftp disk0:
boot system flash disk0:image.bin

etc.

Best Regards,

-- 
-mat