[c-nsp] 7204 viking flash

[Masood Ahmad Shah]

Flash Disks in PC Card slots 0 and 1 are referred to as disk0: and disk1:,
respectively, whereas linear Flash memory cards in PC Card slots 0 and 1 are
referred to as slot0: and slot1:, respectively.

Regards,
Masood Ahmad Shah


-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Mateusz Blaszczyk
Sent: Monday, March 31, 2008 2:19 AM
To: Ibrahim Alsharif
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] 7204 viking flash

Ibrahim,

>  I'm using viking flash Cisco router 7204 when I formatted disk0: it's
done but when i tried to format Slot0: whech holds the flash it gave me this
output: %Error formatting slot0 (Unspecified error).
>  even when i'm trying to access it by dir slot0: it gives me error device
not ready
>

some pcmcia based cards aare referred as disk0 some slot0. If your
card is disk0 then you can not referred to it as slot0. As far as I
understand the process that are different ways to access the physical
drive.
So the card formatted as disk0 should be used like this
eg.
copy tftp disk0:
boot system flash disk0:image.bin

etc.

Best Regards,

-- 
-mat
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/