[c-nsp] 4507R-E loosing config

[Tassos Chatzithomaoglou]

ok, that was what i was guessing too.

lacp/active (as peter said) or pagp/desirable should probably solve the problem.

Otherwise you could write an eem applet (if your switch supports it) that shuts down the 
single port whenever this message appears.

btw, is the whole config lost from the sup or only the one under the specific interface?
If it's the later, you should probably open a tac case.

-- 
Tassos

Sebastian Ganschow wrote on 14/11/2008 11:14:
>> Can you post the errdisable message?
> 
> 00:16:09: %EC-5-BUNDLE: Interface TenGigabitEthernet3/1 joined 
> port-channel Port-channel1
> 00:17:58: %PM-4-ERR_DISABLE: channel-misconfig error detected on Po1, 
> putting Te3/1 in err-disable state
> 00:17:58: %EC-5-UNBUNDLE: Interface TenGigabitEthernet3/1 left the 
> port-channel Port-channel1
> 00:17:58: %PM-4-ERR_DISABLE: channel-misconfig error detected on Po1, 
> putting Te4/1 in err-disable state
> 00:17:58: %EC-5-UNBUNDLE: Interface TenGigabitEthernet4/1 left the 
> port-channel Port-channel1
> 00:17:58: %PM-4-ERR_DISABLE: channel-misconfig error detected on Po1, 
> putting Po1 in err-disable state
> 
> Sebastian
> 
>