[c-nsp] EoMPLS VC up on one side, not on the other.

Christoph Loibl c at tix.at
Sat Nov 15 04:24:00 EST 2008


Hi,

On Nov 15, 2008, at 9:40 AM, Oliver Boehmer (oboehmer) wrote:
>
> you've configured vlan-based EoMPLS (i.e. xconnect on the SVI). In  
> order
> for this to work on Cat65xx/Sup720, you need OSM/SIP as core-facing
> linecard, something which isn't possible on the fixed-configuration
> ME6524..
> So you need to move xconnect to the physical port.

Hm. What is the cisco-speak "correct" name now (which in fact is not  
very intuitive): Vlan-based or SVI-based? Vlan-based is

interface gigabitethernet 1/interface.subinterface
   encapsulation dot1q vlan_id
   xconnect peer_router_id vcid encapsulation mpls
!

This is possible on sup720 even without any fancy linecards. But SVI- 
based

interface vlan 10
   xconnect peer_router_id vcid encapsulation mpls
!

requires those OSM/SIP modules on cat65xx/Sup720 (as Oli wrote) but  
works fine on ME3750. Thus SVI-based (on ME3750) together with VLAN- 
based (on ME6524) should work.

When configuring SVI-based EoMPLS on the ME6524 usually some kind of  
warning is logged ("Config not supported", or "MPLS configured on LAN  
interfaces" as far as I remember).

Stoffi

-- 
CHRISTOPH LOIBL ++++++++++++++++++++++++++++++++++++++++++++++++++++++++
mailto:c at tix.at   |No trees were killed in the creation of this message.
http://www.sil.at |However, many electrons were terrible inconvenienced.
CL8-RIPE ++++++++++++++++++++++++++++++++++++ PGP-Key-ID: 0x4B2C0055 +++





More information about the cisco-nsp mailing list