[c-nsp] ISDN 2x64kbps

[Salik Mobin]

You can optionally use the following command to set up a threshold of load
on which the second channel (in a BRI link) becomes active. 

Router(config-if)#dialer load-threshold VVV either 

where VVV is a number between 1 and 255, 1 being the minimum load and 255
being %100 load on the first channel. This means that this command tells the
router to activate the second channel once the first one is VVV/255 loaded. 

Regards,
Salik 

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of ambedkar
Sent: Wednesday, October 29, 2008 12:43 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] ISDN 2x64kbps

  
Hi,
This is Ambi from india. i am using ISDN connectivity between two 
remote places. i am having one ISDN number which is having 2x64kbps 
capability. when i am connecting with this ISDN number, i am able to 
connect only one B-channel and second B-channel is unable to 
establish.
i have configured the router with the following parameters.

interface BRI1/0
no ip address
encapsulation ppp
dialer pool-member 1
isdn switch-type basic-net3
.
.
.
.
interface Dialer1
ip address 192.168.1.2 255.255.255.0
encapsulation ppp
dialer pool 1
dialer idle-timeout 600
dialer string xxxxxxxxxx
dialer-group 1
!
and vice-versa.

please help me in this regard.
bye.
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/