[c-nsp] Switch Module

[Farhan Ali Khan]

Am not sure but I don't think so there is command in CAT 6513 for module
uptime, however MAY BE " sh hw-module slot XX logging" command will work IF
CWAN card installed.

Cards are hot-swapable check the logs maybe you will get the status from
there 

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Peter Rathlev
Sent: 19 September, 2008 10:09 PM
To: Ahmed Mohamed
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] Switch Module

On Fri, 2008-09-19 at 14:45 +0200, Ahmed Mohamed wrote:
> i have CS65013 switches with some new modules installed on it due to a
> documentation problem, i don't know which module was installed
> recently
> 
> is there any command that can give me the uptime of the module?

You could try "remote command module X show version", but not all
modules support it -- AFAIK they have to have a CFC or DFC. The WS-X6700
modules seem to support it (WS-X6748-GE-TX, WS-X6724-SFP, WS-X6708-10GE
do at least).

Otherwise you could look at the diagnostics, with "show diagnostics
result module X detail". Tests like TestLoopback are not
"non-destructive", and thus only performed at bootup (unless you ask for
it yourself of course). Looking at when the test was performed can tell
you when the module booted.

The diagnostics are performed on all switch modules.

Regards,
Peter


_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/