[c-nsp] ME3400-24FS 12.2(46)SE METROIPACCESS with no MLS QOS commands

[Tassos Chatzithomaoglou]

Mattias,

I believe the default mode is to not change the CoS/DSCP of packets, so you shouldn't have 
any problem.
Also, you can use a policy-map under the interface if you want to modify the above.


-- 
Tassos


Wyatt Mattias Gyllenvarg wrote on 15/04/2009 09:47:
> Hi all!
> 
> I've been racking my brain over this for a day now.
> 
> I have a multicast stream that I have marked with a DSCP value close
> at the core of my net.
> I subscribe too it in an ME3400-24FS (12.2(46)SE METROIPACCESS).
> 
> The problem is that the switch, contrary too documentation, has no
> "mls qos" commands.
> Neither global nor interface commands. I haven't found any reference
> too this "change" anywhere.
> 
> So, how do I get it too trust the DSCP values it on the uplink port so
> I can reserve bandwidth for it on the outgoing port.
> 
> Best regards
> Mattias Gyllenvarg
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>