[c-nsp] Problems with multiple VPDN hops

[Steve McCrory]

Hi Pshem,

Thanks for your reply.

Having the same NAS-IP-Address in both rules is not a typo.

In the first rule, we are saying 'If the NAS IP Address is NOT equal to
213.130.147.56 then apply the following rule'

In the second rule, we are saying 'If the NAS IP Address IS equal to
213.130.147.56 then apply the following rule'

Based on this information, do you have any further suggestions and are
you able to supply example configs of your own setup?

Thanks

Steven
 
Steven McCrory
 
Senior Network Engineer
 
Netservices PLC
Waters Edge Business Park
Modwen Road
Manchester, M5 3EZ
 
www.netservicesplc.com

-----Original Message-----
From: Pshem Kowalczyk [mailto:pshem.k at gmail.com] 
Sent: 24 April 2009 00:41
To: Steve McCrory
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] Problems with multiple VPDN hops

Hi,

{cut}

>
> What I'd like to know is if it's possible to use radius to essentially
> switch packets from one L2TP tunnel into another when they reach LNS2.
>
>
>
> We know that the VPDN and Radius configuration are correct on LNS2
> because we can successfully terminate sessions on this router and
assign
> IP addresses
>

We have a very similar setup with multiple 7301 as the devices in the
middle. Works like a charm.
In your radius config above I've noticed that you use the same
NAS-IP-Address twice - is that a typo?

kind regards
Pshem

--------
NetServices plc, Company No. 4178393,
Registered Office: NetServices House, 31 Modwen Road,
Waters Edge Business Park, SALFORD, M5 3EZ
--------