[c-nsp] xconnect on VLAN interface ES card

[Atif Sid]

I have seen posts on this topic but still not clear.. currentl have WS line
cards, with SUP-32 on 7606; PW on VLAN interface do not work. testing ES
card customer facing, RSP-720 core facing, here is the issue.. any help will
be great !

Is it possible to configure xconnect from an SVI interface, when your core
facing cards are RSP-720?

I have configured it:

interface Vlan290
no ip address
xconnect 10.10.136.129 37123712 encapsulation mpls
end

It does not come up:

PE4#sh mpl l2transport vc

Local intf Local circuit Dest address VC ID Status
------------- -------------------------- --------------- ----------
----------
Vl290 Eth VLAN 290 10.10.136.129 37123712 DOWN

PE4#sh mpl l2transport vc 37123712 det
PE4#sh mpl l2transport vc 37123712 detail
Local interface: Vl290 up, line protocol up, Eth VLAN 290 up
Interworking type is Ethernet
Destination address: 10.10.136.129, VC ID: 37123712, VC status: down
Output interface: none, imposed label stack {}
Preferred path: not configured
Default path: no route
No adjacency
Create time: 00:00:49, last status change time: 00:00:03
Signaling protocol: LDP, peer 10.10.136.129:0 up
Targeted Hello: 10.10.136.131(LDP Id) -> 10.10.136.129
Status TLV support (local/remote) : enabled/not supported
Label/status state machine : remote ready, LndRru
Last local dataplane status rcvd: no fault
Last local SSS circuit status rcvd: AC DOWN(rx,tx faults)
Last local SSS circuit status sent: no fault
Last local LDP TLV status sent: no fault (withdrawn)
Last remote LDP TLV status rcvd: not sent
MPLS VC labels: local unassigned, remote 340
Group ID: local unknown, remote 0
MTU: local unknown, remote 1500
Remote interface description: ** Test PW with PE4 ES SVI int **
Sequencing: receive disabled, send disabled
VC statistics:
packet totals: receive 0, send 0
byte totals: receive 0, send 0
packet drops: receive 0, seq error 0, send 0

Although when I use a physical interface it comes up?
RSP720 does not support it??

 moved it to physical interface it comes up:

interface GigabitEthernet2/1
no ip address
ip verify unicast source reachable-via any
load-interval 30
speed 1000
xconnect 10.10.136.129 37123712 encapsulation mpls
end

PE4#sh mpls l2transport vc
Local intf Local circuit Dest address VC ID Status
------------- -------------------------- --------------- ----------
----------
Gi2/1 Ethernet 10.10.136.129 37123712 UP