[c-nsp] 3560g PoE issue

[Tim Jackson]

Also, if you *KNOW* that those phones are not using 15.4watts you can
setup the power consumption on each port:

int range gi0/1 - 48
 power inline consumption 7700

--
Tim

On Sat, Dec 12, 2009 at 2:13 PM, Buhrmaster, Gary <gtb at slac.stanford.edu> wrote:
>> As i seen in sh power inline o/p few alcatel IP phones are class 0
>> while others class 2. Is this creating the problem ?
>
> Note that all of your class '0' (unrecognized?) devices are
> being allocated 15.4 watts.  That reduces the number of
> other devices you can use.  When your failures occur, look
> at the total power allocated and I suspect you will find
> you are simply out of allocatable power.  The power supply
> of that switch is not capable of providing a full 15.4 watts
> to every port at the same time.
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>