[c-nsp] Controllers for a VWIC2-1MFT-T1/E1

[Everton Diniz]

Hey JAmes,

did you try card type command under global config?

card type {t1 | e1} subslot

http://www.cisco.com/en/US/docs/routers/access/1700/1721/software/feature/guide/t1e11721.html#wp64656

Regards,

On Tue, Dec 15, 2009 at 5:31 PM, james edwards
<lists.james.edwards at gmail.com> wrote:
> I have a 2811 which I am trying to set up an ATM T-1 on. T-1 card and AIM
> are detected:
>
> Cisco 2811 (revision 49.46) with 249856K/12288K bytes of memory.
> 2 FastEthernet interfaces
> 1 Gigabit Ethernet interface
> 1 Channelized (E1 or T1)/PRI port
> 1 ATM/Voice AIM
>
> The  VWIC2-1MFT-T1/E1 came in a bundle with the AIM module. I get this when
> I boot:
>
> ! card type command needed for slot/vwic-slot 0/0,
>
> but the controllers command is not there to configure this card:
>
> yourname(config)#con?
> config-register  configuration  connect  control-plane
>
> What am I missing ?
>
> --
> James H. Edwards
> Senior Network Systems Administrator
> Judicial Information Division
> jedwards at nmcourts.gov
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>