[c-nsp] Controllers for a VWIC2-1MFT-T1/E1

[Gerteisen, Stephen (US SSA) (Contractor)]

I believe the command you're looking for is...

Router(config)#card type t1 0 0


Steve M. Gerteisen
Senior Network Analyst
BAE Systems  

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of james edwards
Sent: Tuesday, December 15, 2009 2:31 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] Controllers for a VWIC2-1MFT-T1/E1

I have a 2811 which I am trying to set up an ATM T-1 on. T-1 card and AIM
are detected:

Cisco 2811 (revision 49.46) with 249856K/12288K bytes of memory.
2 FastEthernet interfaces
1 Gigabit Ethernet interface
1 Channelized (E1 or T1)/PRI port
1 ATM/Voice AIM

The  VWIC2-1MFT-T1/E1 came in a bundle with the AIM module. I get this when
I boot:

! card type command needed for slot/vwic-slot 0/0,

but the controllers command is not there to configure this card:

yourname(config)#con?
config-register  configuration  connect  control-plane

What am I missing ?

-- 
James H. Edwards
Senior Network Systems Administrator
Judicial Information Division
jedwards at nmcourts.gov
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/