[c-nsp] Netflow VRF Command Support in SXI

[Mike Louis]

When you tested it in SXH were you using the /vrf  switch command or just normal netflow? Did you have your mls flow mask set to something other than null?

________________________________________
From: Phil Mayers [p.mayers at imperial.ac.uk]
Sent: Saturday, February 21, 2009 6:30 AM
To: Mike Louis
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] Netflow VRF Command Support in SXI

On Fri, Feb 20, 2009 at 06:59:56PM +0000, Mike Louis wrote:
>I can't use
>
>ip flow-export destination x.x.x.x 9995 vrf VRFNAME
>
>command in SXI. I have heard it was available in SXH? Did it get left out in 12.2(33)SXI?

It seems so - I tested it in SXH but it's not present in SXI for me
either.

HOWEVER - when I tested it in SXH, it was useless - only
software-switched flows were exported, it did not seem to work for
hardware-switches flows. Perhaps that's why it was removed - maybe it
was an unintentional inclusion in SXH?

Note: This message and any attachments is intended solely for the use of the individual or entity to which it is addressed and may contain information that is non-public, proprietary, legally privileged, confidential, and/or exempt from disclosure.  If you are not the intended recipient, you are hereby notified that any use, dissemination, distribution, or copying of this communication is strictly prohibited.  If you have received this communication in error, please notify the original sender immediately by telephone or return email and destroy or delete this message along with any attachments immediately.