[c-nsp] NBAR support for 7600-SIP-400 ?

[Rodney Dunn]

I don't think it is on any other card other than SIP200, Flexwan and then
sup32 PISA.
.

The Flexwan and SIP-200 had some limited support since they were software
forwarding based on some of the VIP code that had NBAR support.

The PISA was the other option for NBAR as you mentioned.

Rodney

On Thu, Mar 12, 2009 at 09:38:43AM +0000, Paolo Lucente wrote:
> Hi Andy,
> 
> Generally you would need a SUP32-PISA supervisor in order to get NBAR
> on a 6500 platform. Don't know about the SIP-400, but i see too there
> is no mention around about it supporting the feature.
> 
> http://www.cisco.com/en/US/prod/collateral/routers/ps368/product_data_sheet0900aecd8027c9e6.html
> 
> Cheers,
> Paolo
> 
> 
> On Thu, Mar 12, 2009 at 11:51:27AM +1100, Andy Saykao wrote:
> > Does anyone know if NBAR is supported on the 7600-SIP-400 (4-subslot SPA
> > Interface Processor-400)? I've applied "ip nbar protocol-discovery" on
> > Gig4/0/2 but do not see any matches. This is a 7606 SUP32 running
> > 12.2(33)SRB3.
> >  
> > interface GigabitEthernet4/0/2
> >  bandwidth 200000
> >  ip address 203.x.x.x 255.255.255.252
> >  ip nbar protocol-discovery
> >  load-interval 30
> >  negotiation auto
> >  mpls ip
> > 
> > #sh ip nbar protocol-discovery interface g4/0/2 top-n 1
> >  
> >  GigabitEthernet4/0/2
> >                             Input                    Output
> >                             -----                    ------
> >    Protocol                 Packet Count             Packet Count
> >                             Byte Count               Byte Count
> >                             30sec Bit Rate (bps)     30sec Bit Rate
> > (bps)
> >                             30sec Max Bit Rate (bps) 30sec Max Bit Rate
> > (bps)
> >    ------------------------ ------------------------
> > ------------------------
> >    bgp                      0                        0
> >                             0                        0
> >                             0                        0
> >                             0                        0
> >    unknown                  0                        0
> >                             0                        0
> >                             0                        0
> >                             0                        0
> >    Total                    0                        0
> >                             0                        0
> >                             0                        0
> >                             0                        0
> > 
> >  
> > Googling around, I found a previous nsp post that said NBAR was only
> > available on the 7600-SIP-200 but this post is 3 years old.
> >  
> > "NBAR with Sup720 is only supported on FlexWAN, Enhanced FlexWAN, and
> > the 7600-SIP-200 modules"
> >  
> > Also read the data sheet on the 7600-SIP-400 and no mention of NBAR
> > support on there?
> >  
> > http://www.cisco.com/en/US/prod/collateral/routers/ps368/product_data_sh
> > eet0900aecd8027c9e6.html
> >  
> > Thanks.
> >  
> > Andy
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/