[c-nsp] NBAR support for 7600-SIP-400 ?

[Andy Saykao]

Hi Andrew,

I tried applying "ip flow ingress" on the interface but still no go.
This is a P MPLS router in our network.

interface GigabitEthernet4/0/2
 bandwidth 200000
 ip address 203.x.x.x 255.255.255.252
 ip nbar protocol-discovery
 ip flow ingress
 load-interval 30
 negotiation auto
 mpls ip 

On other platforms I tested (eg: 7301), even without the "ip flow
ingress", NBAR was still functioning fine.

Thanks for your reply.

Cheers.

Andy


-----Original Message-----
From: Tolstykh, Andrew [mailto:ATolstykh at integrysgroup.com] 
Sent: Friday, 13 March 2009 2:37 AM
To: Andy Saykao; cisco-nsp at puck.nether.net
Subject: RE: [c-nsp] NBAR support for 7600-SIP-400 ?

Do you have "ip flow ingress/egress" or "ip route-cache flow" enabled on
this interface? Also is this a P/PE MPLS router?

SUP-32 supports NetFlow just fine.

Thanks,
Andrew

This email and any files transmitted with it are confidential and intended
 solely for the use of the individual or entity to whom they are addressed. 
Please notify the sender immediately by email if you have received this 
email by mistake and delete this email from your system. Please note that
 any views or opinions presented in this email are solely those of the
 author and do not necessarily represent those of the organisation. 
Finally, the recipient should check this email and any attachments for 
the presence of viruses. The organisation accepts no liability for any 
damage caused by any virus transmitted by this email.